How We Repair Your Zurn Grease Trap
Garbage disposals, trash compactors and grease traps handle kitchen waste with motors, rams, switches and seals.
Every Zurn model has its own parts list, so we start with the model and serial number on the rating label. That tells us the correct parts and any known issues or service bulletins for your unit.
Common Grease Trap Problems We Fix
Leaking under the sink
A loose mounting ring, worn gasket or a cracked housing.
Compactor ram does not move
A worn drive chain or nut, a failed motor or a safety switch.
Grease trap backing up or smelling
It needs pumping or the baffles are damaged.
Disposal hums but does not spin
A jammed flywheel or a failed motor.
Disposal will not turn on
A tripped reset button, a switch or a wiring problem.
Quick Checks Before You Call
These are safe for most owners and sometimes solve the problem without a visit:
- Press the red reset button under the disposal
- With the power off, turn the flywheel with a disposal wrench
- Check that the compactor drawer is fully closed
Still not working? Call (844) 442-1500 or try our troubleshooting wizard.
Our 5-Step Repair Process
- Call or book onlineTell us what your Zurn grease trap is doing and when it started. We schedule the first available visit, with priority for equipment that is stopping your business.
- DiagnosisThe technician checks power, controls and the parts most likely to fail, using the model's service data and test modes.
- Upfront quoteYou get the cause, the repair and the price before any work starts. If repair does not make sense, we tell you.
- RepairWe install original or equivalent parts matched to your model and clean up when we are done.
- Test and warrantyWe run the appliance through a full cycle to confirm the fix. The repair is covered by our 90-day parts and labor warranty.
Parts We Replace Most Often
- Disposal motor unit
- Mounting gaskets
- Reset switch
- Compactor drive nut and chain
- Compactor motor
- Safety switches
Cost and Lifespan
Most grease trap repairs cost $100–$350 including parts and labor, and these appliances typically last 8–15 years. These are national estimates: your exact price comes after the diagnosis. Use the repair vs replace calculator to compare.
Keep It Running Longer
- Keep grease, bones and fibrous food out
- Pump grease traps on schedule
- Run cold water while the disposal runs
Grease Trap Repair in Puerto Rico
We repair grease traps in 87 cities and towns across Puerto Rico. Warm, humid weather all year in Puerto Rico means refrigerators, freezers and air conditioners in homes across the state rarely get a break.
Frequently Asked Questions
How much does Zurn Grease Trap Repair cost in Puerto Rico?
Most grease trap repairs fall between $100–$350 including parts and labor. The final price depends on the part that failed and your model. You get an exact quote after the diagnosis and before any work starts.
Can you repair my grease trap today?
Same-day visits depend on technician availability in Puerto Rico. Call (844) 442-1500 early in the day for the best chance of a same-day or next-day appointment.
Is the repair guaranteed?
Yes. Parts and labor are covered by our 90-day warranty. If the same problem comes back within that time, we return and fix it.
Do you work on all Zurn models?
We repair current and older Zurn models. Some discontinued parts can be hard to find; if that is the case for your model, we tell you before you pay for a repair.
Should I repair or replace my grease trap?
A grease trap typically lasts about 8 to 15 years. If yours is well inside that range and the repair costs less than half the price of a new one, repairing usually makes sense. Near the end of its life, or when the repair costs more than half of a replacement, replacing is often the better value. We give you an honest opinion either way.